Cisco인증 642-883시험을 패스하고 싶다면ITExamDump에서 출시한Cisco인증 642-883덤프가 필수이겠죠. Cisco인증 642-883시험을 통과하여 원하는 자격증을 취득하시면 회사에서 자기만의 위치를 단단하게 하여 인정을 받을수 있습니다.이 점이 바로 많은 IT인사들이Cisco인증 642-883시험에 도전하는 원인이 아닐가 싶습니다. ITExamDump에서 출시한Cisco인증 642-883덤프 실제시험의 거의 모든 문제를 커버하고 있어 최고의 인기와 사랑을 받고 있습니다. 어느사이트의Cisco인증 642-883공부자료도ITExamDump제품을 대체할수 없습니다.학원등록 필요없이 다른 공부자료 필요없이 덤프에 있는 문제만 완벽하게 공부하신다면Cisco인증 642-883시험패스가 어렵지 않고 자격증취득이 쉬워집니다.
Cisco인증 642-883시험은 IT업종종사분들에게 널리 알려진 유명한 자격증을 취득할수 있는 시험과목입니다. Cisco인증 642-883시험은 영어로 출제되는만큼 시험난이도가 많이 높습니다.하지만 ITExamDump의Cisco인증 642-883덤프만 있다면 아무리 어려운 시험도 쉬워집니다. 오르지 못할 산도 정복할수 있는게ITExamDump제품의 우점입니다. ITExamDump의Cisco인증 642-883덤프로 시험을 패스하여 자격증을 취득하면 정상에 오를수 있습니다.
한번에Cisco인증642-883시험을 패스하고 싶으시다면 완전 페펙트한 준비가 필요합니다. 완벽한 관연 지식터득은 물론입니다. 우리ITExamDump의 자료들은 여러분의 이런 시험준비에 많은 도움이 될 것입니다.
우리ITExamDump 에서 제공하는 학습가이드에는 IT전문가들이 만들어낸 시험대비 자료들과Cisco 642-883인증시험의 완벽한 문제와 답들입니다. 그리고 우리ITExamDump에서는 IT업계에서의 높은 신뢰감으로 여러분들한테 100%보장을 드립니다. 우리에 믿음을 드리기 위하여Cisco 642-883관련자료의 일부분 문제와 답 등 샘플을 무료로 다운받아 체험해볼수 있게 제공합니다.
시험 번호/코드: 642-883
시험 이름: Cisco (Deploying Cisco Service Provider Network Routing (SPROUTE) )
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 82 문항
업데이트: 2014-03-30
ITExamDump는 여러분이 Cisco인증642-883시험 패스와 추후사업에 모두 도움이 되겠습니다.ITExamDump제품을 선택함으로 여러분은 시간과 돈을 절약하는 일석이조의 득을 얻을수 있습니다. Cisco인증642-883 인증시험패스는 아주 어렵습니다. 자기에 맞는 현명한 학습자료 선택은 성공의 지름길을 내딛는 첫발입니다. 퍼펙트한 자료만이Cisco인증642-883시험에서 성공할수 있습니다. ITExamDump시험문제와 답이야 말로 퍼펙트한 자료이죠. ITExamDump Cisco인증642-883인증시험자료는 100% 패스보장을 드립니다
ITExamDump의 Cisco인증 642-883덤프로 시험공부를 하신다면 고객님의 시간은 물론이고 거금을 들여 학원등록하지 않아도 되기에 금전상에서도 많은 절약을 해드리게 됩니다. Cisco인증 642-883덤프 구매의향이 있으시면 무료샘플을 우선 체험해보세요.
642-883 덤프무료샘플다운로드하기: http://www.itexamdump.com/642-883.html
NO.1 Which four statements are correct regarding IS-IS operations? (Choose four.)
A. By default, Level 1 routers within an IS-IS area do not carry any routing information external to the area
to which they belong. They use a default route to exit the area.
B. Summarization should be configured on the Level 2 routers, which injects the Level 2 routes into Level
1.
C. IS-IS supports "route leaking" in which selected Level 2 routes can be advertised by a Level 1/Level 2
router into Level 1.
D. The IS-IS backbone is a contiguous collection of Level 1 capable routers, each of which can be in a
different area.
E. With IS-IS, an individual router is in only one area, and the border between areas is on the link that
connects two routers that are in different areas.
F. Cisco IOS XR Software supports multitopology for IPv6 IS-IS unless single topology is explicitly
configured in IPv6 address-family configuration mode.
Answer: A,C,E,F
Cisco 642-883기출문제 642-883 642-883
NO.2 Which three statements are true regarding the OSPF router ID? (Choose three.)
A. The OSPF routing process chooses a router ID for itself when it starts up.
B. The router-id command is the preferred procedure to set the router ID.
C. If a loopback interface is configured, its address will always be preferred as the router ID over any
other methods.
D. After the router ID is set, it does not change, even if the interface that the router is using for the router
ID goes down. The router ID changes only if the router reloads or if the OSPF routing process restarts.
E. In OSPF version 3, the OSPF router ID uses a 128-bit number.
Answer: A,B,D
Cisco 642-883 642-883시험문제
NO.3 In comparing IS-IS with OSPF, a Level-1-2 IS-IS router is similar to which kind of OSPF router?
A. ASBR on a normal OSPF area
B. ASBR on NSSA
C. ABR on totally stubby OSPF area
D. ABR on stubby OSPF area
E. ABR on a normal OSPF area
Answer: C
Cisco자격증 642-883 642-883 642-883
NO.4 Refer to the OSPF command exhibit.
Which effect does the no-summary command option have?
A. It will cause area 1 to be able to receive non-summarized inter-area routes.
B. It will cause area 1 to not receive any inter-area routes and will use a default route to reach networks in
other areas.
C. It will cause area 1 to not receive any external routes and will use a default route to reach the external
networks.
D. It will convert the NSSA area into a NSSA totally stubby area.
E. It will convert the stubby area into a NSSA.
F. It will disable OSPF auto-summary.
Answer: B
Cisco 642-883 642-883시험문제 642-883최신덤프 642-883
NO.5 When troubleshooting OSPF neighbor errors, which three verification steps should be considered.?
(Choose three.)
A. Verify if neighboring OSPF interfaces are configured in the same area.
B. Verify if neighboring OSPF interfaces are configured with the same OSPF process ID.
C. Verify if neighboring OSPF interfaces are configured with the same OSPF priority.
D. Verify if neighboring OSPF interfaces are configured with the same hello and dead intervals.
E. Verify if neighboring OSPF interfaces are configured with the same area type.
Answer: A,D,E
Cisco시험문제 642-883최신덤프 642-883
NO.6 On Cisco IOS XR Software, which set of commands is used to enable the gi0/0/0/1 interface for OSPF
in area 0?
A. interface gi0/0/0/0 ip address 10.1.1.1 255.255.255.0 ! router ospf 1 network 10.1.1.1 0.0.0.0 area 0
B. interface gi0/0/0/0 ip address 10.1.1.1 255.255.255.0 ! router ospf 1 network 10.1.1.1 255.255.255.255
area 0
C. router ospf 1 area 0 interface GigabitEthernet0/0/0/1
D. interface gi0/0/0/0 ip address 10.1.1.1 255.255.255.0 ip ospf 1 area 0
E. router ospf 1 address-family ipv4 unicast interface GigabitEthernet0/0/0/1 area 0
F. router ospf 1 address-family ipv4 unicast interface GigabitEthernet0/0/0/1 area 0
Answer: C
Cisco자료 642-883 642-883 642-883최신덤프 642-883자료
NO.7 Which two OSPF network scenarios require OSPF virtual link configuration? (Choose two.)
A. to connect an OSPF non-backbone area to area 0 through another non-backbone area
B. to connect an NSSA area to an external routing domain
C. to connect two parts of a partitioned backbone area through a non-backbone area
D. to enable route leaking from Level 2 into Level 1
E. to enable route leaking from Level 1 into Level 2
F. to enable OSPF traffic engineering
Answer: A,C
Cisco dump 642-883최신덤프 642-883최신덤프 642-883자격증
NO.8 Refer to the PE1 router routing table output exhibit.
What is causing the i su 10.1.10.0/24 [115/30] via 0.0.0.0, 00:40:34, Null0 entry on the PE1 router routing
table?
A. The PE1 router is receiving the 10.1.10.0/24 summary route from the upstream L1/L2 IS-IS router.
B. The PE1 router has been configured to summarize the 10.1.10.x/32 IS-IS routes to 10.1.10.0/24.
C. The 10.1.10.0/24 has been suppressed because IS-IS auto-summary has been disabled on the PE1
router.
D. The 10.1.10.0/24 has been suppressed because of a route policy configuration on the PE1 router.
E. The 10.1.10.0/24 has been suppressed because the more specific 10.1.10.x/32 IS-IS routes have
been configured to leak into the IS-IS non-backbone area.
Answer: B
Cisco덤프 642-883 642-883 642-883 642-883자격증
NO.9 When configuring IPv4 and IPv6 IS-IS routing on Cisco IOS XR routers, which three statements are
correct? (Choose three.)
A. By default, a single SPF is used for both IPv4 and IPv6, so the IPv4 and IPv6 topology should be the
same.
B. By default, the IS-IS router type is Level 1 and Level 2.
C. All IS-IS routers within the same IS-IS area must be configured with the same IS-IS routing process
instance ID.
D. By default, metric-style narrow is used.
E. By default, the IS-IS interface circuit type is Level 1 and Level 2.
F. The area IS-IS address-family configuration command is used to specify the IS-IS area address.
Answer: B,D,E
Cisco 642-883 642-883 642-883 642-883최신덤프 642-883시험문제
NO.10 What is function of the RP/0/RSP0/CPU0:PE1(config-ospf)#distance Cisco IOS-XR command?
A. To modify the administrative distance of the OSPF routes
B. To modify the default seed metric of the OSPF external routes
C. To modify the OSPF default reference bandwidth
D. To modify the OSPF cost
Answer: A
Cisco시험문제 642-883시험문제 642-883 642-883 642-883기출문제
ITexamdump의 70-414덤프의 VCE테스트프로그램과 HP5-K01D덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 000-784시험에 대비한 고품질 덤프와 000-656시험 최신버전덤프를 제공해드립니다. 최고품질 VCAP5-DCD시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기