HP HP0-Y43 시험을 어떻게 통과할수 있을가 고민중이신 분들은ITExamDump를 선택해 주세요. ITExamDump는 많은 분들이 IT인증시험을 응시하여 성공하도록 도와주는 사이트입니다. 최고급 품질의HP HP0-Y43시험대비 덤프는HP HP0-Y43시험을 간단하게 패스하도록 힘이 되어드립니다. ITExamDump 의 덤프는 모두 엘리트한 전문가들이 만들어낸 만큼 시험문제의 적중률은 아주 높습니다.
HP 인증 HP0-Y43시험이 너무 어려워서 시험 볼 엄두도 나지 않는다구요? ITExamDump 덤프만 공부하신다면 IT인증시험공부고민은 이젠 그만 하셔도 됩니다. ITExamDump에서 제공해드리는HP 인증 HP0-Y43시험대비 덤프는 덤프제공사이트에서 가장 최신버전이여서 시험패스는 한방에 갑니다. HP 인증 HP0-Y43시험뿐만 아니라 IT인증시험에 관한 모든 시험에 대비한 덤프를 제공해드립니다. 많은 애용 바랍니다.
시험 번호/코드: HP0-Y43
시험 이름: HP (Implementing HP Network Infrastructure Solutions Exam)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 62 문항
업데이트: 2013-09-22
ITExamDump의 덤프선택으로HP HP0-Y43인증시험에 응시한다는 것 즉 성공과 멀지 않았습니다. 여러분의 성공을 빕니다.
네트워크 전성기에 있는 지금 인터넷에서HP 인증HP0-Y43시험자료를 많이 검색할수 있습니다. 하지만 왜ITExamDump덤프자료만을 믿어야 할가요? ITExamDump덤프자료는 실제시험문제의 모든 유형에 근거하여 예상문제를 묶어둔 문제은행입니다.시험적중율이 거의 100%에 달하여HP 인증HP0-Y43시험을 한방에 통과하도록 도와드립니다.
ITExamDump의 HP 인증 HP0-Y43시험덤프공부자료 출시 당시 저희는 이런 크나큰 인지도를 갖출수 있을지 생각도 못했었습니다. 저희를 믿어주시고 구매해주신 분께 너무나도 감사한 마음에 더욱 열심히 해나가자는 결심을 하였습니다. HP 인증 HP0-Y43덤프자료는ITExamDump의 전문가들이 최선을 다하여 갈고닦은 예술품과도 같습니다.100% 시험에서 패스하도록 저희는 항상 힘쓰고 있습니다.
HP0-Y43 덤프무료샘플다운로드하기: http://www.itexamdump.com/HP0-Y43.html
NO.1 View the exhibit.
A network administrator wants to configure an HP 5800 switch to place all incoming traffic on the
GigabitEthernet 1/0/1 port in priority queue 3. However, one exception applies. All traffic incoming on that
port that is destined to UDP port 55555 should be forwarded in priority queue 4 and marked with DSCP
32.
Based on the current configurations shown in the exhibit, which further steps must the network
administrator perform? (Select two.)
A. Configure port GigabitEthernet 1>0/1 to trust DSCP
B. Apply QoS policy Policy1 as on inbound policyon port GigabitEthernet 1/0/l
C. Apply QoS policy Policy2 as on inbound policyon port GigabitEthernet 1/0/1
D. Create a OoS Ip-dscp mapthat maps Ip value 4 to DSCP02
E. Undo OoS trust on port GigabitEthernet 1/0/1
Answer: B,E
HP pdf HP0-Y43 HP0-Y43시험문제
NO.2 View the exhibits.
Exhibit 1
The frame has these characteristics:
-VLANID = 3
-802.1p = 3
-DSCP=32
-Source IP address = 10.1.1.5
Click here for Exhibit 2
The frame shown in Exhibit 1 arrives on an HP 5800 switch's GigabitEthernet port 1/0/1. QoS maps are at
their default settings. Based on the configuration shown in Exhibit 2, to which queue is the outbound
packet assigned?
A. 2
B. 3
C. 4
D. 5
Answer: D
HP시험문제 HP0-Y43 HP0-Y43자료 HP0-Y43
NO.3 A network includes a mix of IGMPv2 and IGMPv3 endpoints and must support the following source
specific multicasting applications:
-Source: 10.1.4.2 and Group: 232.0.5.5
-Source: 10.1.4.12 and Group 232.0.6.6
The network is already implementing PIM-SM and IGMPv3. In order to support these applications, the HP
10500 switches that act as routers for the endpoints in question must support another feature. Which step
must the network administrator perform on each of these switches?
A. Create an SSM policy that includes 232.0.5.5 and 232.0.6.6 within its range
B. Enable IGMPv2 backward compatibility mode
C. Configure two SSM maps, each of which mapsa source to its multicast group
D. Enable PIM SSM on the interfaces that connect to the endpoints
Answer: C
HP HP0-Y43시험문제 HP0-Y43 HP0-Y43
NO.4 How can a high density of ports and high throughput at the core of an HP FlexNetwork save customers
money?
A. Intelligence is offloaded from the edge switches, enabling customers to save money on the most
numerous switches in their solutions.
B. The customer can combine the data center and campus LAN core into a single entity, reducing power
and cooling costs.
C. The customer no longer needs to deploy modular switches at the distribution level and the edge,
deploying more cost-effective stackable switches instead.
D. The architecture can be simplified, eliminating expensive distribution devices and reducing power and
cooling costs.
Answer: D
HP HP0-Y43 HP0-Y43기출문제 HP0-Y43 HP0-Y43인증
NO.5 Which switch is best suited to act at the edge of a medium to large HP FlexFabric solution?
A. 10500
B. 5500
C. 9500
D. 5830
Answer: D
HP HP0-Y43 dump HP0-Y43자격증 HP0-Y43인증
NO.6 A company has a network that includes HP 5800 and 12500 switches. Usage demands on the
company's FTP servers have increased, causing performance issues during peak usage times. While
analyzing link utilization, the network administrator noticed that the most heavily utilized links experience
bursts of congestion, causing them to drop traffic. The links then experience brief periods of low utilization
followed by another burst of congestion. This pattern continues periodically throughout the peak utilization
time.
What should the network administrator do to attempt to create a more efficient traffic pattern on these
links?
A. Configure an outbound traffic policing policy on the ports in question, setting the CIR at about sixty
percent of the ports' capacity and the PIR at about eighty percent.
B. Apply Weighted Fair Queuing (WFQ) or Weighted Round Robin (WRR) scheduling in preference to
Strict Priority (SP) scheduling on the ports in question.
C. Configure inbound traffic policing policies on ports at the core, setting the CIR at about sixty percent of
the ports' capacity and the PIR at about eighty percent. Apply outbound generic traffic shaping (GTS) on
ports facing the core ports, setting the CIR equal to the CIR on the core ports.
D. Apply a WRED table to the ports in question, optionally adjusting the table values to drop lower priority
traffic first.
Answer: D
HP HP0-Y43 HP0-Y43
NO.7 What is the role of neighbor solicitation (NS) messages in the autoconfiguration of an IPv6 address.?
A. An IPv6 node sends an NS message to inform a node undergoing autoconfiguration that it is already
using a particular address.
B. An IPv6 node sends an NS message for its tentative address to determine whether another node is
using it.
C. An IPv6 node sends an NS message for the global prefix to prompt other IPv6 nodes to advertise the
addresses that they are using on that prefix.
D. An IPv6 node sends an NS message to prompt an IPv6 router on the link to advertise the global
prefixes associated with the link immediately.
Answer: B
HP HP0-Y43 pdf HP0-Y43 HP0-Y43 dump HP0-Y43인증
NO.8 View the exhibit.
The exhibit shows a network with HP 5400 zl and 8200 zl switches throughout the core and edge. What is
one advantage of implementing routing on edge switches?
A. Typically, it is easier to implement user-based VLAN assignments.
B. The topology has higher redundancy because edge switches can take over routing roles when
necessary.
C. Typically, the network can use fewer total VLANs when edge switches implement routing.
D. Typically, it is easier to ensure that routed links between edge and core switches are fully utilized.
Answer: D
HP HP0-Y43인증 HP0-Y43기출문제 HP0-Y43 dump
NO.9 A customer requires an HP FlexCampus solution with a core that scales to 40/100G. Which HP switch
fabric meets this need?
A. the 7500's CLOS switch fabric
B. the 10500's CLOS switch fabric
C. the 7500's crossbar switch fabric
D. the 10500's crossbar switch fabric
Answer: B
HP HP0-Y43 pdf HP0-Y43 HP0-Y43
NO.10 A company has a service level agreement (SLA) with its service provider. The SLA specifies a 2 Mbps
committed information rate (CIR) and 20 KB committed burst size (CBS). Lately, during peak usage times,
the company has been experiencing brief periods of poor performance on its external connection
(GigabitEthernet port 2/0/1 on an HP 5800 switch).
How can the network administrator configure the Comware switch to address this problem?
A. Configure a traffic classifier that selects all traffic and a car traffic behavior that sets the CIR to 2 Mbps
and the CBS to 20 KB. Create a QoS policy that maps the classifier to the action and apply this policy as
an inbound policy on port GigabitEthernet 2/0/1.
B. Enable Strict Priority (SP) scheduling on port GigabitEthernet 2/0/1 and ensure that all inbound traffic is
marked with the correct priority.
C. Configure generic traffic shaping (GTS) on the GigabitEthernet port 2/0/1, setting the CIR to 2 Mbps
and the CBS to 20 KB.
D. Configure a traffic classifier that selects all traffic and a car traffic behavior that sets the CIR to 2 Mbps
and the CBS to 20 KB. Create a OoS policy that maps the classifier to the action and apply this policy as
an outbound policy on port GigabitEthernet 2/0/1.
Answer: C
HP HP0-Y43인증 HP0-Y43자료
ITexamdump의 HP3-C33덤프의 VCE테스트프로그램과 70-342덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 HP0-J62시험에 대비한 고품질 덤프와 70-687시험 최신버전덤프를 제공해드립니다. 최고품질 CAT-221시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기