2013년 12월 16일 월요일

Juniper JN0-522 인증시험

ITExamDump의Juniper인증 JN0-522덤프의 인지도는 아주 높습니다. 인지도 높은 원인은Juniper인증 JN0-522덤프의 시험적중율이 높고 가격이 친근하고 구매후 서비스가 끝내주기 때문입니다. ITExamDump의Juniper인증 JN0-522덤프로Juniper인증 JN0-522시험에 도전해보세요.

우리ITExamDump 사이트에서Juniper JN0-522관련자료의 일부 문제와 답 등 샘플을 제공함으로 여러분은 무료로 다운받아 체험해보실 수 있습니다.체험 후 우리의ITExamDump에 신뢰감을 느끼게 됩니다.빨리 우리 ITExamDump의 덤프를 만나보세요.

시험 번호/코드: JN0-522
시험 이름: Juniper (FXV,Associate (JNCIA-FWV))
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 160 문항
업데이트: 2013-12-15

Juniper인증JN0-522시험덤프공부자료는ITExamDump제품으로 가시면 자격증취득이 쉬워집니다. ITExamDump에서 출시한 Juniper인증JN0-522덤프는 이미 사용한 분들에게 많은 호평을 받아왔습니다. 시험적중율 최고에 많은 공부가 되었다고 희소식을 전해올때마다 ITExamDump는 더욱 완벽한Juniper인증JN0-522시험덤프공부자료로 수정하고기 위해 최선을 다해왔습니다. 최고품질으Juniper인증JN0-522덤프공부자료는ITExamDump에서만 찾아볼수 있습니다.

많은 사이트에서도 무료Juniper JN0-522덤프데모를 제공합니다.우리도 마찬가지입니다.여러분은 그러한Juniper JN0-522데모들을 보시고 다시 우리의 덤프와 비교하시면 ,우리의 덤프는 다른 사이트덤프와 차원이 다른 덤프임을 아시될것입니다, 우리ITExamDump에서 제공되는 덤프는 100%보장 도를 자랑하며,여러분은 시험패스로 인해 성공과 더 가까워 졌답니다

Juniper인증JN0-522시험을 패스하기가 어렵다고 하면 합습가이드를 선택하여 간단히 통과하실 수 잇습니다. 우리ITExamDump에서는 무조건 여러분을 위하여 관연 자료덤프 즉 문제와 답을 만들어낼 것입니다. 우리덤프로Juniper인증JN0-522시험준비를 잘하시면 100%Juniper인증JN0-522시험을 패스할 수 있습니다. ITExamDump덤프로 여러분은Juniper인증JN0-522시험을 패스는 물론 여러분의 귀증한 간도 절약하실 수 있습니다.

JN0-522 덤프무료샘플다운로드하기: http://www.itexamdump.com/jn0-522.html

NO.1 Which statement is correct about tunnel interfaces?
A.They can have overlapping IP addresses.
B.They need to be configured in the zone where the protected resources reside.
C.They can be unnumbered and used in policy-based translations if the interface is in route mode.
D.They can be unnumbered from any interface residing on the same virtual router as the protected
resources.
Answer:D

Juniper   JN0-522덤프   JN0-522   JN0-522

NO.2 What needs to be configured in Phase 2 of a route-based VPN, that does not need to be configured in a
policy-based VPN?
A.proxy-id
B.tunnel-binding
C.transport mode
D.custom proposals
Answer:B

Juniper최신덤프   JN0-522   JN0-522 dumps

NO.3 Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no
cookie. Which two should be verified? (Choose two.)
A.routes
B.Phase 1 configuration options
C.Phase 2 configuration options
D.selected quick mode encryption algorithms
Answer:A B

Juniper dumps   JN0-522   JN0-522   JN0-522 pdf   JN0-522

NO.4 Click the Exhibit button. In the exhibit, if host A initiates a Web browsing session with host D, and the
E0/1 interface of the SSG 20 is in NAT mode, what will be the source address of the packet arriving at
host D?
A.10.1.1.1
B.10.1.10.5
C.143.45.56.1
D.143.45.56.254
Answer:C

Juniper기출문제   JN0-522   JN0-522   JN0-522   JN0-522기출문제

NO.5 Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B

Juniper인증   JN0-522   JN0-522

NO.6 Click the Exhibit button. In the exhibit, which two forms of address translation would have generated
the output shown? (Choose two.)
A.MIP
B.NAT-src with no DIP
C.Interface-based translation
D.NAT-src with a DIP, fixed-port disabled
Answer:B C

Juniper시험문제   JN0-522 pdf   JN0-522 pdf   JN0-522

NO.7 Click the Exhibit button. In the exhibit, what is the correct command to configure a default route on the
SSG 20?
A.set route 0.0.0.0/0 vrouter untrust
B.set route 0.0.0.0/0 interface e0/4 gateway 143.45.56.254
C.set route 0.0.0.0/0 interface e0/4 next-hop 143.45.56.254
D.set route 0.0.0.0/0 interface 143.45.56.1 gate 143.45.56.254
Answer:B

Juniper   JN0-522자격증   JN0-522최신덤프   JN0-522

NO.8 What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D

Juniper   JN0-522   JN0-522

NO.9 Click the Exhibit button. Traffic from the Internet to the partner servers must use a VIP. In the exhibit,
what is true about the configuration of this feature?
A.You cannot use a VIP in this environment.
B.The VIP can be configured on the e0/4 interface.
C.The VIP can be configured in the Corporate or Internet zone using a different subnet than the physical
interface.
D.The VIP will work only if the destination ports in the incoming packet headers are mapped to the same
ports in the Corporate zone.
Answer:A

Juniper자료   JN0-522   JN0-522 pdf

NO.10 What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
A.There is no need to reconfigure the IP addresses of routers or protected servers.
B.There is no need to create MIPs or VIPs for incoming traffic to reach protected servers.
C.Policies are easier to create since you do not have to include source and destination IP addresses.
D.The product can support more VPNs and obtain greater throughput because there is less overhead to
manage.
Answer:A B

Juniper   JN0-522   JN0-522자료   JN0-522

NO.11 Assuming factory default settings, which statement describes the minimum requirements for WebUI
management access to the SSG 5?
A.Connect a PC addressed on the 192.168.1.0 subnet to any interface, open a browser and access
192.168.1.1.
B.Terminate the bootup sequence from the console device, open a browser on the console device and
access 192.168.1.1.
C.Connect a PC addressed on the 192.168.1.0 subnet, to the highest numbered interface and open a
browser and access 192.168.1.1.
D.Using the CLI, define an IP address on a physical interface, connect a PC to the interface and open a
browser to the interface address.
Answer:C

Juniper덤프   JN0-522자료   JN0-522   JN0-522

NO.12 Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A

Juniper   JN0-522   JN0-522   JN0-522 pdf

NO.13 You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C

Juniper자격증   JN0-522   JN0-522   JN0-522자료

NO.14 Which ScreenOS CLI command would be used to view traffic logs?
A.get traffic
B.get log policy
C.get policy log
D.get log traffic
Answer:D

Juniper덤프   JN0-522   JN0-522자료   JN0-522인증

NO.15 Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D

Juniper   JN0-522덤프   JN0-522자격증   JN0-522 pdf

NO.16 Which ScreenOS CLI policy statement keyword would enable a policy only during specified times, days,
and/or dates?
A.at
B.calendar
C.schedule
D.scheduler
Answer:C

Juniper덤프   JN0-522   JN0-522   JN0-522

NO.17 What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A

Juniper   JN0-522   JN0-522

NO.18 Click the Exhibit button. In the exhibit, which routing command would allow host A to communicate with
host C? (Note: Assume a route from the SSG 20 to host A's subnet already exists.)
A.set route 0.0.0.0/0 int e0/3 gateway 177.11.56.254
B.set route 1.1.70.0 interface e0/3 gateway 177.11.56.254
C.configure route 1.1.70.0/24 gateway 177.11.56.254 int e0/3
D.set route 1.1.70.0/24 interface e0/3 gateway 177.11.56.254
Answer:D

Juniper   JN0-522   JN0-522   JN0-522

NO.19 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.255
How many MIP address translations have you just configured?
A.1
B.8
C.128
D.256
Answer:A

Juniper덤프   JN0-522 dumps   JN0-522기출문제   JN0-522   JN0-522   JN0-522최신덤프

NO.20 Click the Exhibit button. In the exhibit, what is the correct address book entry for host C?
A.set address C 1.1.70.250/32
B.set address Partner C 1.1.70.250
C.set address Partner 1.1.70.250/32
D.set address Partner C 1.1.70.250/32
Answer:D

Juniper기출문제   JN0-522   JN0-522덤프   JN0-522   JN0-522최신덤프   JN0-522

ITexamdump의 000-283덤프의 VCE테스트프로그램과 JN0-633덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 000-275시험에 대비한 고품질 덤프와 C_HANASUP_1시험 최신버전덤프를 제공해드립니다. 최고품질 VCAW510시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.

시험자료링크: http://www.itexamdump.com/jn0-522.html

댓글 없음:

댓글 쓰기